6: Configuration Via Telnet or Serial Port (Setup Mode)
xDirect User Guide 37
Password :----
Press Enter for Setup Mode
3. Enter User Name (user name is admin and cannot be changed). Pressing the Enter key after
entry is not necessary. The Password field will appear.
4. Enter Password (default password is PASS). Pressing the Enter key after entry is not
necessary. You will be prompted to enter Setup Mode.
Note: Password can be modified or disabled. See Server Configuration (on page 26).
5. To enter Setup Mode, press Enter within 5 seconds. The configuration settings display (see
Figure 6-2), followed by the Change Setup menu.
Figure 6-2 Setup Menu Options
*** basic parameters
Hardware: Ethernet TPI
IP addr - 0.0.0.0/DHCP/BOOTP/AutoIP, no gateway set
DNS Server not set
Telnet config password set
DHCP device name : not set
DHCP FQDN option: Disabled
*** Security
SNMP is enabled
SNMP Community Name: public
Telnet Setup is enabled
TFTP Download is enabled
Port 77FEh is enabled
Web Server is enabled
Web Setup is enabled
ECHO is disabled
Encryption is disabled
Enhanced Password is disabled
*** Channel 1
Baudrate 9600, I/F Mode 4C, Flow 00
Port 10001
Connect Mode : C0
Send ‘+++’ in Modem Mode enabled
Show IP addr after ‘RING’ enabled
Auto increment source port disabled
Remote IP adr: --- none ---, Port 00000
Disconn Mode : 00
Flush Mode : 00
*** Expert
TCP Keepalive : 45s
ARP cache timeout: 600s
CPU performance: Regular
Monitor Mode @ bootup : enabled
HTTP Port Number : 80
MTU Size: 1400
To Next Page
Loading...
Need help?
General
