6: Configuration Via Telnet or Serial Port (Setup Mode)
xDirect User Guide 38
TCP Re-transmission timeout: 500 ms
Alternate MAC: disabled
Ethernet connection type: auto-negotiate
Change Setup:
0 Server
1 Channel 1
5 Expert
6 Security
7 Defaults
8 Exit without save
9 Save and exit Your choice? _
6. Select an option on the menu by entering the number of the option in the Your choice? field
and pressing Enter.
7. To enter a value for a parameter, type the value and press Enter, or to confirm a current value,
just press Enter.
8. When you are finished, save the new configuration (option 9). The unit reboots.
Serial Port Connection
To configure the unit through a serial connection:
1. Connect a console terminal or PC running a terminal emulation program to your unit's serial
port. The default serial port settings are 9600 baud, 8 bits, no parity, 1-stop bit, no-flow
control.
2. Reset the xDirect unit by cycling the unit's power (turning the power off and back on).
Immediately upon resetting the device, enter three lowercase x characters (xxx).
Note: The easiest way to enter Setup Mode is to hold down the x key at the terminal (or
emulation) while resetting the unit. You must do this within three seconds of resetting
the xDirect.
At this point, the screen display is the same as when you use a Telnet connection. To continue, go
to step 6 in Telnet Connection above.
Exiting Setup Mode
Two options through which to exit setup mode:
To save all changes and reboot the device, select option 9 Save and exit from the Change
Setup menu. All values are stored in nonvolatile memory.
To exit the configuration mode without saving any changes or rebooting. select option 8 Exit
without save from the Change Setup menu.
To Next Page
Loading...
Need help?
General
