Lantronix XPort User Guide

7: 59BSetup Mode: Channel Configuration
XPort® Device Server User Guide 58
Disable or enable the XPort device’s ability to send the escape sequence. The default is Y
(Yes) (send the escape sequence).
Show IP addr after 'RING'
Show IP addr after ‘RING’ <Y> ?
Disable or enable the XPort module's ability to show the IP address after RING in Modem
Mode. The default is Y (Yes), to show the IP address.
Auto Increment Source Port
Auto increment source port (N) ? _
Y (Yes) auto increment the source port. The XPort unit increments the port number used with
each new connection.
Remote IP Address
This is the destination IP address used with an outgoing connection.
Remote IP Address : (000) .(000) .(000) .(000)_
Note: This option does not display when Hostlist is enabled from the ConnectMode prompt
(see Connect Mode on page 51 for more information).
Remote Port
You must set the remote TCP port number for the unit to make outgoing connections. This
parameter defines the port number on the target host to which a connection is attempted.
Remote Port (000) ? _
To connect an ASCII terminal to a host using the unit for login purposes, use the remote port
number 23 (Internet standard port number for Telnet services).
Note: This option does not display when Hostlist is enabled from the ConnectMode prompt
(see Connect Mode on page 51 for more information).

Lantronix XPort Specifications

General

Data Link Protocol	Ethernet, Fast Ethernet
Connectivity Technology	Wired
Form Factor	Embedded
Category	Embedded Systems
Interface	Serial
Serial Ports	1
Operating Temperature	0°C to 70°C