Lantronix XPort User Guide

8: Setup Mode: Advanced Settings
XPort® Device Server User Guide 71
Disable Port 77FEh (N) ? _
The default setting is the N (No) option, which enables remote configuration. You can
configure the unit by using DeviceInstaller, web pages, Telnet, or serial configuration.
The Y (Yes) option disables remote configuration and web sites.
Note: The Y (Yes) option disables many of the GUI tools for configuring the unit, including
the embedded Web Manager tool.
77FEh Access Mode
Configuring this setting is available if port 77FE is enabled. This option will not be listed if
port 77FE is disabled.
Set 0 for Read & Write mode, and 1 for Read Only mode. Default value of this setting is
Read-Write(0).
If access mode is Read-only, then read operation can be done through port 77FE, if Read-
Write access is selected, then both read and write of data can be done through port 77FE.
77FEh Access Mode (0=Read & Write, 1=Read Only): (0) ? _
Disable Web Server
This setting defaults to the N (option). The Y (Yes) option disables the web server.
Disable Web Server (N) ? _
Disable Web Setup
The Y (Yes) option disables configuration using the Web Manager. This setting defaults to
the N (option).
Disable Web Setup (N) ? _
Disable ECHO Ports
This setting controls whether port 7 echoes characters it receives.
Disable ECHO ports (Y) ? _
Enable Encryption
Rijndael is the block cipher algorithm chosen by the National Institute of Science and
Technology (NIST) as the Advanced Encryption Standard (AES) to be used by the US
government. The XPort module supports 128-, 192-, and 256-bit encryption key lengths.

Lantronix XPort Specifications

General

Data Link Protocol	Ethernet, Fast Ethernet
Connectivity Technology	Wired
Form Factor	Embedded
Category	Embedded Systems
Interface	Serial
Serial Ports	1
Operating Temperature	0°C to 70°C