Lars Thrane LT-3100 - Page 121

LT-3100 User & Installation Manual Rev. 1.06 Web server
Lars Thrane A/S www.thrane.eu Page 110 of 155
If the LT-3100 system is connected to a local network as illustrated in Figure 149, where a DHCP server is
already available, then the LT-3100 system must be configured to either DHCP client or Static mode. The
Static mode can be used, if it is required that the IP-address of the LT-3110 Control Unit must never change.
The LT-3100 system has two reserved network ranges, which are documented in Table 28.
IMPORTANT: Do not connect the LT-3100 System to any external IP networks, which are not trusted. The
LT-3110 Control Unit has Firewall rules configured on all Ethernet ports to avoid unwanted
IP traffic.
DHCP client
The DHCP client mode is the configuration of the LT-3110 Control Unit from the factory. The DHCP client
mode must be used, if the IP network already has a DHCP server available.
Figure 149: Web server - Network
Reserved Network Ranges
Reserved
Sub-nets
Reserved External
192.168.255.0/24 - i.e. 192.168.255.0 netmask 255.255.255.0
Reserved Internal
172.27.0.0/16 - i.e. 172.27.0.0 netmask 255.255.0.0
Table 28: Reserved Network Ranges