Starting up
15.05.01
YACE0060
21
$
$$
$
− A double signal tone sounds.
− The display for LEVEL (low-level) appears.
− The fault triangle is flashing
− Press the key. If necessary repeat several times.
− Also press the key if the unit had switched off under a fault
condition.
6.3 Setpoint selection (level 0)
or
− Input the setpoint with one of the keys.
− Speeding the setting process by:
a) continuous pressing the keys or
b) pressing one key (holding it down) and shortly pressing
the other key.
− Briefly releasing (1 s) the key (s) and again pressing one of
the keys moves the cursor one place to the right.
− Display flashes 4 s ! the new value is accepted
automatically, or
− Value is entered immediately with this key.
☞
− For safety reasons the setpoint can only be adjusted up to 2 °C above the upper limit of
the operating temperature range of the particular unit type