Starting up
15.05.01
YACE0060
23
6.4.2 Pump output
and 1x
− For setting the pump output from level 0 press the key
combination shown on the left, or
− move forward from COOL function with this key.
− The display shows the current bath temperature, PUMP and
the current output step. To alter the setting press the key
shown on the left.
− Display flashes (approx. 4 s).
or
− During this time start to set the required step with one of the
keys.
0 = pump stopped, heating off
1 = low pump output
2 , 3 , 4 = medium pump output
5 = maximum pump output
− The pump responds immediately (can be heard). (Setting is
entered after approx. 4 s ➾ Section 6.4.)
− Move forward with key to "Selecting the setpoint resolution"
or
− back with the key to "Setpoint selection".
To Next Page
Loading...