Starting up
26
6.4.4.1 Setting the proportional band of the PID-controller
and 3x
− Directly from level 0 (setpoint selection), press the key
combination on the left, until the PARA function is
reached, then
− switch to level 2 from PARA (see above) with key on the
left.
or
− Within this level it is possible to scroll with the keys.
− The display shows the current bath temperature Xp
and the current setting. To alter the setting press the
key on the left. Available settings from 0,5 to 9,9 °C .
(➾ Section 6.4.4.2.
☞
Note).
(➾ Section 9. Technical data))
− Display flashes (approx. ca. 4 s).
or
− During this time start to set the required value with one
of the two keys
− Forward with the key to "Setting the reset time" or
− with the key back to "PARA".
To Next Page
Loading...