Starting up
15.05.01
YACE0060
29
6.4.4.4 Setting the Baud rate/ transfer rate (serial interface)
and 3x
− Directly from level 0 (setpoint selection), press the key
combination on the left, until the PARA function is
reached, then
and 3x
− switch to level 2 and move forward with key on the left.
− The display shows the current bath temperature, KBD
and the current setting. To alter the setting press the key.
− Display flashes (approx. 4 s).
or
− During this time, start to set the required value with one
of the two keys.
Settings available: 2400, 4800, 9600 or 19200 baud
− Forward with key to "user calibration" or
− Forward with key to "user calibration" or.
To Next Page
Loading...