Integral T process thermostats
54 Starting up YAWE 0026 / 21/01/2019
When communication between thermostat and FBT is
interrupted there is a fault message and acoustic signal.
This is also the case when the FBT is switched off.
Unit is switched off as is in case of fault.
Release after the eliminating the cause of fault (only
possible at the thermostat!).
7.6.4.2 Manual Start - Autostart
Select "Manual Start“ or "Auto start“ when mains are
ON.
0 = Manual Start
I = Auto start
In case of "Auto start" the unit is started automatically
as soon as mains are switched ON or in case of voltage
failure as soon as voltage returns.
In case of "Manual Start" the key has to be
pressed each time the mains are switched ON or after
mains failure and return.
To Next Page
Loading...
Need help?
General
