Safety & Accessory
Initial UseDiagnosticsFAQ & Care
Product Prole
43
www.x431.com +86 755 8455 7891
LAUNCH
PAD VII
User Manual
Note: During the SmartLink diagnosis, especially during remote online programming, it is recommended that
the vehicle baery is connected to a charging power source. Doing so can prevent the vehicle from running out
of power and failing to start due to long diagnosis me.
end into the LAN port of network modem.
Note: The network broadband of 100MB and above is required for this operaon.
4. After a successful network connection, the SmartLink C screen displays prompt information asking
whether to enter the super remote diagnostic mode. Tap Yes, the system will automatically read the
vehicle information and connect to the remote diagnosis server.
Note: One SmartLink C can only accept one remote diagnosc operaon at one me.
5. Turn on the vehicle ignition.
Note: Aer receiving the order, the SmartLink B master technician will accept the order and contact you via
phone or E-mail address.
message will be displayed on the SmartLink C screen.
To Next Page
Loading...
