Launch X-431 PADII - Page 20

LAUNCH
X-431 PADII User's Manual
15
Fig. 5-5
1. If you are a new user, tap “New Register” to enter registration page.
See Fig. 5-6.
Fig. 5-6
In Fig. 5-6, fill in the information in each field (Items with * must be
lled). After inputting, tap “Register”, a screen similar to the following
will appear:
Fig. 5-7
In Fig. 5-7, input the Serial Number and Activation Code, which can be
found in the password envelope.
Product S/N
Activation Code
Fig. 5-8
Note: To exit and activate it later, tap “Skip”. In this case, you can
activate your connector by tapping “Activate Connector” in “Profile”.
For details, please refer to Chapter 5.8.2 Activate Connector.
Tap “Activate” to nish your registration. See Fig. 5-9.
Fig. 5-9
To download the diagnostic software, tap “Go To Update Center”. See
Fig. 5-10.
Tap “Download Later” to download and install it later. Refer to Chapter
5.5 Download/Update Diagnostic Software.