Launch X-431 PADII - Page 42

LAUNCH
X-431 PADII User's Manual
37
9.2 About Endoscope
1
3
4
2
6
5
Fig. 9-1
1
Snapshot button: To take a snapshot of the current view
and save it to your LAUNCH diagnostic tool as an image.
2
Flexible tube: You can bend the neck to get in to hard-to-
reach places and even if it is not straight, it can still give you
pictures of what the camera is looking at. (Note: Do NOT
force it too hard while bending the neck into strange shapes.)
3
Dial for LED light brightness: There are 4 LED lights in the
lens that act like a torch to illuminate dark spots where the
camera can not see well. This dial allows you to adjust the
light brightness.
4
Handle
5
Camera with 4 adjustable LED lights: The camera head
is water-resistant and is where you can attach the useful
optional accessories (magnet, mirror, hook) add-on.
6
USB cable: Connect it to LAUNCH diagnostic tool for viewing
what the camera captures.
9.3 Technical Parameters
Resolution 640 x 800 pixel (VGA)
Frame Rate 30fps (pictures/sec)
Image Sensor 1/12" CMOS
White Balance Automatic
Exposure Automatic
Light Source 4 adjustable LEDs
USB Port USB1.1/2.0/3.0
Power Supply 5V via USB
Ambient temperature 0 to +65
o
C
USB Cable Length Approx. 2000mm
Probe & Camera Length 1030mm
Probe Cable Length 830mm
Min. Bending Radius 50mm