Network HDD Recorder User Manual
20
Select OK to continue. The Partitioning screen displays.
Using the and navigation
buttons, select the partitioning
ratio. Changes made are shown
on the screen.
The FAT32 partition is named
HDD1 and the NTFS partition is
named HDD2 on the media
screens. See Using the Network
HDD Recorder on page 28 for
more information.
NTFS HDDs are read-only; you cannot save, delete or rename content
on the NTFS partition through the recorder.
At least 10% of the HDD MUST be reserved for the FAT32
format.
Select Next to continue.
The Hard Disk Format screen
displays.
Select Format to begin formatting the HDD.
The formatting time varies depending on the HDD capacity.
To Next Page
Loading...
Need help?
General