14–9
CHANGE PARAM — for modifying parameters.
On line
To select for modification up to five different parameters, “1”, “2”,
“3”, “4”, or “5”.
Category
To specify the category of parameter. When “All” is selected, the
“measure” menu (see below) will feature all parameters. However,
when a particular category is selected, only those parameters in the
category are shown.
DELETE ALL PARAMETERS
For deleting all parameters previously selected.
measure
To choose the new parameter to be measured on this line.
When “– –” is selected the line is not used.
of
For selecting the channel or trace on which the parameter will be
measured (four-channel menu shown).
To Next Page
Loading...
