WaveJet 300A Remote Control Manual
917976 Rev A 13
2.16 Response to the identification common query, *IDN?
See the list of commands.
2.17 Size of protected user data storage area if the *PUD command and *PUD? query are
implemented
Not implemented.
2.18 Size of resource description if the *RDT command or *RDT? query are implemented.
Not implemented.
2.19 States affected by *RST, *LRN?, *RCL, and *SAV
Table 2-8. List of states affected
Name State
*RST Same as Recall Default Setup
*LRN Not implemented
*RCL Same as Recall Setup
*SAV Same as Save Setup
2.20 Scope of self-test performed by the *TST? query
The Acquisition Memory test is conducted.
2.21 Additional status data structures used in the device’s status reporting
Status Byte Register
Table 2-9. Model of Status Byte Register
Bit Definition Implemented?
7 Device-Defined Summary Message No (always zero)
6 Master Summary Status Yes
5 Standard Event Status Bit (ESB) Summary Message Yes
4 MAV Queue Summary Message Yes (only GPIB)
3 Device-Defined Summary Message No (always zero)
2 Device-Defined Summary Message No (always zero)
1 Device-Defined Summary Message No (always zero)
0 Trigger Event Status Bit (TESB) Summary Message Yes
Service Request Enable Register
An application programmer can select which summary messages in the Status Byte Register may cause
service requests.
To Next Page
Loading...
