EasyManua.ls Logo

LeCroy WaveJet 300A series - 1 Introduction to Wavejet 300 A Remote Control Interfaces; WJ-A-GPIB Hardware; WJ-A-LAN Hardware

LeCroy WaveJet 300A series
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WaveJet 300A Remote Control Manual
1. INTRODUCTION TO WAVEJET 300A REMOTE CONTROL INTERFACES
The WaveJet 300A supports remote control through USB, GPIB and TCP/IP. USB is supported as a standard
feature, GPIB and TCP/IP are available with optional interface boards.
The WJ-A-GPIB and WJ-A-LAN are optional interface boards exclusively for the WaveJe 300A series.
Insert the board into one of the option slots on the rear of the WaveJet 300A before use.
It can be inserted into either of the two option slots provided.
Once the board is inserted into the slot, the WaveJet main unit automatically recognizes it as a remote
interface, allowing you to select it.
The WJ-A-GPIB and the WJ-A-LAN can be inserted at the same time, but only one of them can be selected.
Two of the same kind of interface board must not be inserted at the same time (prohibited).
CAUTION!
To prevent damage to the instrument, turn instrument power OFF before inserting a WJ-A-GPIB or
WJ-A-LAN interface board.
ESD Sensitive
The WJ-A-GPIB and WJ-A-LAN interface boards are sensitive to electrostatic discharge
(ESD). To avoid causing damage to the boards, always follow anti-static procedures (wear
wrist strap, etc.) when handling the boards.
1.1 WJ-A-GPIB Hardware
Applicable standard GPIB IEEE-488.1
Usable unit WaveJet 3xx series firmware 3.xx or later
Power supply Supplied from WaveJet3xx option slot
Power consumption Included in WaveJet3xx main unit
Dimensions
63 mm × 80 mm (excluding protrusion of connector terminal)
Mass Approximately 70 g
Operating temperature range
0 to 40 °C
Operating humidity range
80% RH or lower (when operated within 0 to 40 °C)
Storage temperature range
-20 to +60 °C
1.2 WJ-A-LAN Hardware
Applicable standard
TCP/IP 10BASE-T/100BASE-T
Usable unit WaveJet 3xx series firmware 3.xx or later
Power supply Supplied from WaveJet3xx option slot
Power consumption Included in WaveJet3xx main unit
Dimensions
63 mm × 80 mm (excluding protrusion of connector terminal)
Mass Approximately 55 g
Operating temperature range
0 to 40 °C
Operating humidity range
80% RH or lower (when operated within 0 to 40 °C)
Storage temperature range
-20 to +60 °C
917976 Rev A 5

Table of Contents

Other manuals for LeCroy WaveJet 300A series

Related product manuals