LeCroy WaveJet 300A series - Horizontal and Acquisition Systems

WaveJet 300A Series
18 917976 Rev A
6. REMOTE COMMANDS
This list of remote commands is alphabetized by short form.
Horizontal ACQ
Command/Query
DESCRIPTION The ACQ command selects the acquisition mode. The ACQ?
query returns the current selection of the acquisition
mode.
COMMAND SYNTAX ACQ <mode>
<mode>:={NORMAL, PEAK, AVERAGE} (When XYDS is YT)
<mode>:={NORMAL, AVERAGE} (When XYDS is XYTRG)
<mode>:={NORMAL} (When XYDS is XY)
QUERY SYNTAX ACQ?
RESPONSE FORMAT <mode>
REMARKS ACQ AVERAGE sets ROLL OFF automatically.
Acquisition ASET
Command
DESCRIPTION The ASET command provides the auto setup.
COMMAND SYNTAX ASET
QUERY SYNTAX
RESPONSE FORMAT
Horizontal AVGCNT
Command/Query
DESCRIPTION The AVGCNT command sets the number of events to average
.
AVGCNT? query returns the number set.
COMMAND SYNTAX AVGCNT <number>
<number>:={2, 4, 8, 16, 32, 64, 128, 256}
QUERY SYNTAX AVGCNT?
RESPONSE FORMAT <number>
REMARKS AVGCNT command reports device-
s
pecific error (DDE) and
is not performed when ACQ is not AVERAGE.
Vertical BWL
Command/Query
DESCRIPTION The BWL command enables or disables the bandwidth limit
(low-pass filter) of the specified input channel. The
BWL? query returns the selected status.
COMMAND SYNTAX <channel>: BWL <mode>
<channel>: = {C1, C2, C3, C4} (WJ354/334/324/314)
: = {C1, C2} (WJ352/332/322/312)
<mode>: = {OFF, 100M, 20M} (WJ354/334/352/332)
: = {OFF, 20M} (WJ324/314/322/312)
QUERY SYNTAX <channel>:BWL?
RESPONSE FORMAT <mode>
The current bandwidth limit status (low-pass filter)