OPERATOR’S MANUAL
WRXi-OM-E Rev C 113
Parameter Description Definition Notes
Delta delay
delay: Computes time between
50% level of two sour
Time between midpoint Standard parameter.
ces. transition of two
sources
Dperiod@level
Adjacent cycle deviation (cycle-to-
cycle jitter) of each cycle in a
waveform
Reference levels and edge-
transition polarity can be
selected. Hysteresis argument
used to discriminate levels from
noise in data.
Available with JTA2 and XMAP
options.
Dtime@level
t at level: Computes transition
between selected levels or sources.
Time between
transition levels of two
sources, or from trigger
to transition level of a
ource
Reference levels and edge-
transition polarity can be
selected. Hysteresis argument
used to discriminate levels from
noise in data. single s
This measurement
gives the time of the
source 2 edge minus
the time of the source 1
edge.
Standard parameter.
Duration
For single sweep waveforms, dur is
: time from previous
t's to current segment's
ted waveform's
Time from first to last Standard parameter.
0; for sequence waveforms: time
from first to last segment's trigger;
for single segments of sequence
acquisition: for
average, histogram or
sequence waveforms
waveforms
segmen
trigger; for waveforms produced by
a history function: time from first to
last accumula
trigger.
Duty@level
e
scriminate levels from
Available with JTA2 and XMAP
Percent of period for which data ar
above or below a specified level.
Reference levels and edge-
transition polarity can be
selected. Hysteresis argument
used to di
noise in data.
options.
Duty cycle
rcentage of
period.
riod Standard Duty cycle: Width as pe width/pe parameter.
Dwidth@level
Difference of adjacent width above
or below a specified level.
t
d XMAP
Reference levels and edg
transition polarity can be
e-
selected. Hysteresis argumen
used to discriminate levels from
noise in data.
Available with JTA2 an
options.
To Next Page
Loading...
Need help?
General
