LeCroy WaveRunner XI Series User Manual

WAVERUNNER XI SERIES
124 WRXi-OM-E Rev C
Parameter Description Definition Notes
TAA
Average peak-to-trough
amplitude for all local features. om noise
Hysteresis argument used to
discriminate levels fr
in data.
Available with DDM2 option.
Standard in DDA-5005A.
TAA-
Average local baseline-to-
trough amplitude for all local
is argument used to
m noise
features.
Hysteres
discriminate levels fro
in data.
Available with DDM2 option.
Standard in DDA-5005A.
TAA+
Average local baseline-to-peak
amplitude for all local feature .
to
noise
ption.
Standard in DDA-5005A.
s
Hysteresis argument used
discriminate levels from
in data.
Available with DDM2 o
TIE@level
pe and level and the
Slope
ositive,
ut
e or
unit interval
You can also use a
mathematically derived Golden
PLL to filter low frequency jitter.
Cutoff Freq = (1/1.667e3) x
Clock Freq
Reference levels and edge-
transition polarity can be
selected. Hysteresis argument
used to discriminate levels
from noise in data.
Available with JTA2 and
XMAP options.
Difference between the
measured times of crossing a
given slo
ideal expected time. For
you can choose p
negative, or both. For outp
units you can choose tim
unit interval (UI). A
equals one clock period.
The Virtual Clock setup gives
you a choice of Standard
(1.544 MHz) or Custom
reference clocks.
The cutoff frequency is user
selectable.
Time@level
ger
(t=0) to crossing at a specified
level.
Time from trigger to crossing
level
ent
vels
Time at level: Time from trig Reference levels and edge-
transition polarity can be
selected. Hysteresis argum
used to discriminate le
from noise in data.
Standard parameter.

LeCroy WaveRunner XI Series Specifications

General

Brand	LeCroy
Model	WaveRunner XI Series
Category	Test Equipment
Language	English