To Next Page

To Previous Page

WAVERUNNER XI SERIES

210 WRXi-OM-E Rev C

Example

ou can reach the MATLAB Editor where you will see the default waveform function. If

and create a MATLAB function that performs

n be a one-line call of your MATLAB function.

MATLAB Waveform Function Editor -

By touching Edit Code, y

you are familiar with MATLAB, you might prefer to launch MATLAB

your task. Your program in the instrument could the

This is the default waveform function, with one important change – the semi-colon (;) has been removed from the

end of the line. If the semicolon is p cause the output values will not

be shown in MATLAB Response. isplay it could be he

response va l du itho roduce a

visible MATL

From this panel you can save your code, load a previous code, and edit your func

MATLAB is an entire wave . The two input wa n1 and

WformIn2, while the outpu ut. You can al vidual samples, suc In1(34), and

WformOut(34:55) = WformIn(34:55)

WformOut(233:377) = WformIn(100:244)

resent, your function will run much faster, be

With a long waveform, the time needed to d

ring development and debugging. Any line w

quite long. T

ut a semicolon will plues can be usefu

AB Response.

tion. A powerful feature of

veforms are WformI

h as Wform

that you can refer to

t is WformO

form as a vector

so refer to indi

sequences of samples, such as WformIn(55:89)

You can write statements such as these:

formOut(5) = WformIn(5)

formOut(89) = WformIn(144)

LeCroy WaveRunner XI Series User Manual

Questions and Answers: