LEGRAND DX2 Series - Page 39

Numbers Components
CC and DC channels.
• Top row:•
Four CC channels (CC2 - CC5).
Two DC channels (DC1 - DC2).
• Boom row:•
One CC channel (CC1).
See
Connecng Detectors/Actuators to DX (on page 50) for how to
connect CC sensors or DC actuators.
DIP switches for conguring the Normal state of each CC channel. See
Adjusng DIP Switches (on page 53).
• Top row:•
DIP switch 1 controls CC2.
DIP switch 2 controls CC3.
DIP switch 3 controls CC4.
DIP switch 4 controls CC5.
• Boom row:•
DIP switch 1 controls CC1.
DIP switch 2 controls the built in hall effect sensor.
Tip: If an alert is shown for this hall eect sensor, you can disable it
by turning on/o DIP switch 2.
39