LEGRAND DX2 Series - Appendix C Sensor Measurement Accuracy

Appendix C Sensor Measurement Accuracy
This secon shows the factory specicaons of environmental sensor packages. Calibraon is not
required for these sensor packages.
In This Chapter
DX2 Sensor Accuracy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 57
DX2 Sensor Accuracy
• Temperature: +/-1.0 degree Celsius (when temperature = 20 to 70 degrees Celsius)•
• +/-1.0 degree Celsius is equal to +/-1.8 degrees Fahrenheit•
• Humidity: +/-5% (when humidity = 10% to 90%)•
•
Dierenal Air Pressure: +/- 1.5% FS at 25 degrees Celsius, 50% RH; Range: -250 - 250 Pa
•
• Airow: Range: 0-4 m•
• Floor Water Sensor: Range: 0-10 meters•
• Rope Water Sensor: Range: 0-10 meters, Cable length: +/- 0.5 meter at 25 degrees Celsius, 64% RH;•
Leak distance: +/- 1 meter at 25 degrees Celsius, 50% RH, 10 meter cable. Note: when mulple
simultaneous leaks are detected, leak distance accuracy of 1 meter is not guaranteed. Check the
whole distance of the rope for mulple leaks if the leakage distance provided does not locate a leak.
57