Page 10
301 Fulling Mill Road, Suite G ©Copyright 2015 by Legrand,
Middletown, PA 17057 Inc All Rights Reserved.
(800) 321-2343 www.legrand.us
For the Interlogix Concord 4 System, the SB2000 Automation Module (Part# 60-783-02) is
required. A DB9 to RJ45 plug-in adapter is supplied with the HA7000 Intuity Controller that will
allow a direct connection from the Intuity Controller into the SB2000.
For the Interlogix NetworX Security System, an NX-584 Automation Module is required.
Please refer to the manual that is supplied with the NX-584 Automation Module for further
instructions on setup.
The following must be configured on the NX-584:
The Jumper positions need to be set opposite of the default on the NX-584 Automation Module:
J7 = B
J8 = A
J9 = A
J10 = B
To Next Page
Loading...
Need help?
General
