Leica Digilux 3 - Taking Pictures using the Built-in Flash

Advanced
58
Taking Pictures using
the Built-in Flash
w Open the flash
Press the [FLASH] button .
• If you press the [FLASH] button lightly, the
flash will open to the bounce flash position
. If you press the [FLASH] button fully,
the flash will open to the normal flash
position .
• Use the flash in the normal flash position
when taking pictures with the flash normally.
w Close the flash
: Press the flash down until it locks into
the bounce flash position.
: Close the flash completely.
• This camera is compatible with bounce
flash so the flash opens and closes in two
steps.
Refer to P62 for information about the
bounce flash.
• Be sure to close the flash when not in use.
w Switching to the appropriate flash
setting
Set the flash to match the recording.
1 Press [ ] .
: Viewfinder Display
: When taking pictures with Live View
2 Rotate the command dial  and
select the flash setting.
• Refer to “Available flash setting by
recording mode” on P59 for information
about the flash settings for the built-in
flash that can be selected.
• Refer to P83 for setting the 1st and 2nd
curtain.
C
B
A
F
STANDARD
STANDARD
ISO
ISO
100
100
AUTO
AUTO
WB
WB
19
19
SINGLE
SINGLE
NORMAL
NORMAL
CUSTOM
CUSTOM
P
ISO
ISO
100
P
STD
STD
19
19
AUTO
D
E
STANDARD
STANDARD
ISO
ISO
100
100
AUTO
AUTO
WB
WB
19
19
SINGLE
SINGLE
NORMAL
NORMAL
CUSTOM
CUSTOM
P
G