5.4303.8558.0 -
Maintenance 7-7
Figure 27. Make sure the ultrasonic sensor arm is in the boundaries of the bumper
Figure 28. Adjust the ultrasonic sensor arm to an angle of maximum 60˚
Adjust the tube length of the ultrasound sensor
1. Support the ultrasonic sensor manually.
2. Loosen nut (2).
3. Put the ultrasonic sensor on the correct length.
4. Tighten the nut (2).
Adjust the angle of the ultrasound sensor head
1. Support the ultrasonic sensor manually.
in n o vato rs in agriculture
To Next Page
Loading...
