5.4303.8558.0 -
7-8 Maintenance
2. Loosen nut (3).
3. Put the ultrasonic sensor in the correct angle.
4. Tighten the nut (3).
Close-up
1. Manually drive the machine to the charging station.
2. Put the machine into operation.
7.3.7 Examine the Drive Wheels
Preparation
1. Take the machine out of operation.
2. Manually drive the machine to a clean and quiet location.
Examine
1. Open the cover of the machine.
2. Examine the profile of the drive wheels. If the profile is less than 2 mm, call your local Lely service
provider for replacement of the tyres.
Close-up
1. Manually drive the machine to the charging station.
2. Put the machine into operation.
7.3.8 Calibrate the Wheels
Preparation
1. Take the machine out of operation.
2. Manually drive the machine to a clean and quiet location with a flat floor.
3. Make sure you have at least 5 m (16 ft) of free driving distance.
Calibrate
1. Tap
.
2. Tap Settings.
3. Tap Wheels.
4. Tap Assisted calibration.
5. Tap button Start. The machine drives forward.
6. After driving at least 5 m (16 ft), tap button Stop. The message
Measure Driven Distance, enter the distance and press calibrate is displayed.
7. Measure the exact distance the machine has driven (in mm).
8. Tap Ok.
in n o vato rs in agriculture
To Next Page
Loading...
