5.4303.8558.0 -
Troubleshooting 8-5
Symptom
Possible cause
Action
Feed push power set too high or
too low for this feed type.
1. Set feed push power.
While pushing feed, feed is
coming under the skirt or the
feed alley is not clean.
The skirt is too high.
1. Call your local Lely service
provider.
The skirt is worn.
1. Call your local Lely service
provider.
The action Straight drive
backward is too long.
1. Call your local Lely service
provider.
The machine drives over feed.
1. Call your local Lely service
provider.
The backup process of the
routes does not function.
The software version of the
smartphone is not correct.
Make sure the software version
on the smartphone is correct. If
the version is not correct update
the smartphone software.
8.3.2 Troubleshooting Table Juno Charging Station
Symptom
Possible cause
Action
Green LED is off. Power disconnected.
1. Connect the power supply.
Battery loader defect.
1. Call your local Lely service
provider.
8.4 Reset the Machine when it is connected to the Charging Station
Do this procedure to reset the machine when the machine is at the
charging station and you can’t establish the connection between the
smartphone and the machine.
Reset the Machine
1. Push the emergency stop button.
2. Push and hold the pause button for approximately 5 seconds. A beep sounds and the machine
electronics restart.
3. Pull the emergency stop button to deactivate it.
in n o vato rs in agriculture