Measuring
7
3. MEASURING
Operation is simple:
Set measuring function/range with central selector
Q
Connect instrument,
trigger measurement with start key R read measured value.
ATTENTION: Do not operate the central selector during measurement, from
pressing the start key to the display of the result!
Please observe the following instructions for optimum usage of the instrument:
3.1 General
CAUTION! In case of temperature changes from well below freezing to above
freezing, dewing may occur. In this case wait for at least 30 minutes in temperature
ranges > 0°C before putting the instrument into operation At temperatures below 0
°C use fresh batteries if possible because of reduced battery capacity.
3.2 POWER-ON Functions
After switching on the instrument, the display test (all LCD segments showing) will
appear for approx. 5 s. During this phase it is possible to obtain special operating
modes:
a) Normal Mode,
If the display test elapses without further key presses, the instrument will
automatically return to stand-by mode (display „---“) approx. 60 s after
completion of a measurement or key press or after operation of the rotary
selector, call up old measured values with key
S „Display“ or perform a
measurement with key R „Start“.
b) Stand By Off
Simultaneous depression of the two keys „Display“ and „ “ after turning on
until the end of the display test prevents the changeover to stand-by. The
battery-saving stand-by mode can not be re-enabled until the central selector is
switched off.
To Next Page
Loading...
Need help?
General
