Need help?Do you have a question about the LEM NORMA 5000 and is the answer not in the manual?
General| Brand | LEM |
|---|---|
| Model | NORMA 5000 |
| Category | Measuring Instruments |
| Language | English |
Safety guidelines specific to the device housing, mains connection, and input voltage.
Details the terminals, ports, and interfaces located on the rear panel of the power analyzer.
Describes the front panel controls, display elements, and their functional assignments.
Provides instructions for installing and safely switching on the power analyzer.
Outlines the safe sequence for connecting circuits to the power analyzer.
Details direct, shunt, and transducer connections for 1-phase measurements.
Details direct and shunt connections for 3-phase measurement in a 4-wire system.
Describes the default factory configuration 1:W3 and its suitability for measurements.
Guides on accessing General Setup and System Info menus for device information.
Explains how to load, save, and delete configurations for analyzer settings.
Explains how to configure current and voltage channel inputs and ranges.
Explains switching current input to BNC for external shunts/probes.
Outlines essential steps to perform before starting any measurement.
Introduces FFT for analyzing signal frequency components, including modes and views.
Guides on configuring the PI1 interface for motors/generators, sensors, and outputs.
Provides detailed technical specifications for the NORMA 4000 model.
Lists general technical specifications like interface, housing, weight, and display.
Details voltage and current specifications, ranges, and input impedance.
Shows the limit of error for different power phases and readings.
Provides detailed technical specifications for the NORMA 5000 model.
To Next Page
