Figure 65. Installation of a fan module
After this task is completed
• If applicable, reinstall the intrusion switch (see “Install an intrusion switch with cable” on page 98).
• Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 161).
Demo video
https://www.youtube.com/watch?v=ygqsqNfmKYs
Front operator assembly replacement
Follow instructions in this section to remove or install a front operator assembly.
Remove the front operator assembly
Follow instructions in this section to remove the front operator assembly.
About this task
To avoid potential danger, make sure to read and follow the safety information.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
Chapter 5. Hardware replacement procedures 93
To Next Page
Loading...
