Lenovo ThinkEdge SE350 V2 - Cable Routing for the Power Module Board and Power Input Board Module

Cable routing for the power module board and power input board
module
Follow instructions in this section to learn how to do cable routing for the power input board (PIB) module
and power module board (PMB).
Attention:
• For a smooth installation, connect the cables between the power module board and power input board
module BEFORE installing the power module board.
Cable
From To
1
LED connector on the power module
board
PMB status LED on the power input board module
2 & 3 Two connectors on the power module
board
Important:
• When connecting these power cables,
make sure to distinguish cables
2 and
3 and connect them correctly to their
respective connectors. Switching these
cables will cause failure.
Two connectors on the power input board module
Figure 128. Cable routing for the power input board module and power module board
Procedure of installing the PMB-PIB cables:
Step 1. Make preparations for this task.
• Install the power input board module with LED cable (see
“Install a power input board module”
on page 120
).
Step 2. Connect and organize the three cables (
1 & 2 & 3 ) for the power input board module and power
module board.
a.
Connect the PMB status LED cable ( 1 ) to the power module board.
b.
Connect the power cables 2 and 3 to the two connectors on the PIB module and the two
connectors on the PMB.
Important:
172
ThinkEdge SE350 V2 User Guide