b. Remove the screw that secures the keylock switch to the sidewall of the node.
c.
Slightly push the keylock switch rightward; then, remove it from the node.
Figure 72. Removal of the keylock switch with cable
Step 3. (Optional) If necessary, remove the keylock switch cable from the bracket.
a.
Press and hold on the latches on both sides of the keylock switch.
b. Meanwhile, pull the switch with cable away from the bracket as illustrated.
Figure 73. Removal of the keylock switch with cable from the bracket
After this task is completed
• If necessary, install a replacement unit (see
“Install a keylock switch with cable” on page 102).
Chapter 5. Hardware replacement procedures 101
To Next Page
Loading...
