CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read
“Installation Guidelines” on page 37 and “Safety inspection checklist” on page 38 to make sure that
you work safely.
• Remove the shipping bracket, if applicable (see
“Configuration guide” on page 45); then, power off the
server and disconnect the power cords (see
“Power off the server” on page 44).
• Lay the node on a flat, static-protective surface.
Procedure
Step 1. Carefully place the node or node sleeve upside down.
Step 2. Remove a rubber pad by pulling it from the node or node sleeve.
Figure 96. Removal of a rubber pad
Step 3. (Optional) If necessary, repeat the same step for the other three rubber feet.
After this task is completed
• If necessary, install a replacement unit (see
“Install the rubber feet” on page 132).
• If you are instructed to return the component, follow all of the packaging instructions and use any
packaging materials for shipping that are supplied to you.
Demo video
Chapter 5. Hardware replacement procedures 131
To Next Page
Loading...
