Figure 102. Removal of the bridge board screws
Step 3. Slightly pull the bridge board toward the front of the node to remove it.
Figure 103. Removal of the bridge board
After this task is completed
• Install a replacement unit (see
“Install a bridge board” on page 148).
• If you are instructed to return the component, follow all of the packaging instructions and use any
packaging materials for shipping that are supplied to you.
Demo video
https://www.youtube.com/watch?v=wcFw7YtLDI8
Remove the system board (trained technician only)
Follow instructions in this section to remove the system board. This procedure must be executed by a
trained technician.
Chapter 5. Hardware replacement procedures 139
To Next Page
Loading...
