Figure 105. Removal of the system board
Step 4. Pivot the system board at an angle; then, fully remove it from the chassis.
Figure 106. Removal of the system board
After this task is completed
• Install a replacement unit (see
“Install a system board (trained technician only)” on page 144).
• If you are instructed to return the component, follow all of the packaging instructions and use any
packaging materials for shipping that are supplied to you.
Demo video
https://www.youtube.com/watch?v=AxjkLjm1CUE
Chapter 5. Hardware replacement procedures 143
To Next Page
Loading...
