• Go to https://datacentersupport.lenovo.com/products/servers/thinkedge/se350v2/7da9/downloads/driver-list
to see the latest firmware and driver updates for your server.
• Go to “Update the firmware” on page 177 for more information on firmware updating tools.
Procedure
Step 1. Make preparations for this task.
a. Carefully lay the node on a flat, static-protective surface.
Step 2. Insert the system board into the node at an angle as illustrated.
Figure 107. Installation of a system board
Step 3. Carefully slide the system board toward the rear of the node; then, seat the system board onto the
guide pins of the chassis.
Figure 108. Installation of a system board
Step 4. Tighten the screws and standoffs as illustrated to secure the system board.
Chapter 5. Hardware replacement procedures 145
To Next Page
Loading...
