Lenovo ThinkEdge SE350 V2 - Page 56

Step 3. Depending on the specific configuration, the procedure of removing the enclosure from the rails
can be one of the following.
Procedure 1: by sliding the enclosure out of the rails.
1. Slide the enclosure out of the rails.
–
Open the rack release latches in the front of the enclosure; then, slowly slide out the
enclosure until it stops.
–
Press the release latches on the rail.
–
Carefully lift the enclosure away from the rack.
Figure 22. Removal of the enclosure from the rack by sliding
2. (Optional) If necessary, remove the inner rails from the enclosure.
– If applicable, remove the screws that secure the inner rails on the enclosure.
Figure 23. Removal of the screws from inner rails
– Push the inner rails as shown to disengage the inner rails from the mounting pins on the
enclosure.
–
Remove the inner rails from the enclosure when the mounting holes on the inner rails are
aligned with the corresponding rail mounting pins on the enclosure.
48
ThinkEdge SE350 V2 User Guide