Figure 45. Installation of a power adapter into the support bracket , 2U2N enclosure
Step 3. Connect the power adapter cable to the node.
Step 4. Install the power cable cover onto the power adapter support bracket.
a. For a 1U2N enclosure: align the power cable cover with the slot; then, push the cover slightly
toward the rear of the node until it clicks into place.
Figure 46. Installation of a power cable cover, 2U2N enclosure
b. For a 2U2N enclosure: align the power cable cover with the slot; then, push the cover slightly
toward the front of the node until it clicks into place.
Chapter 5. Hardware replacement procedures 67
To Next Page
Loading...
