Figure 59. Installation of Drive-backplane 1
Note: The hex standoffs are designed to be used with a common Phillips screwdriver or flat-
head screwdriver.
Step 3. Install Drive backplane 2 (upper).
a. Align Drive backplane 2 (upper) with the screw holes and edges of Drive backplane 1 (lower)
and the drive cage.
b. Place the backplane down and engage it in position.
c. Tighten the three screws to secure Drive-backplane 2 to Drive-backplane 1.
Figure 60. Installation of Drive-backplane 2
After this task is completed
• Proceed to install the drive cage into the node (see
“Install a drive cage” on page 86).
• Connect all necessary cables to the drive backplane(s) (see
“Cable routing for the hot-swap drives” on
page 165
).
Attention: Before connecting the drive-backplane cables, make sure that the power input board module
and the power module board are installed in place.
Chapter 5. Hardware replacement procedures 85
To Next Page
Loading...
