Lenovo ThinkServer 1045 - Removing or Installing the Microprocessor

3.NoticetheorientationoftheheatsinkairowandtheV-shapedcoolingpipe.TheV-shapedcooling
pipeshouldalwaysfacethepowersupplyassembly.Then,aligntheretainingscrewsontheheatsink
withthecorrespondingholesinthesystemboard.Installthefourscrewsfollowingthenumerical
sequenceasshownbelow(
1to4)tosecuretheheatsinkonthesystemboard.
Figure55.Installingtheheatsink
1-4Screws
5Airow
6Thefrontofthechassis
Whattodonext:
•Toworkwithanotherpieceofhardware,gototheappropriatesection.
•Tocompletetheinstallation,goto“Completingthepartsreplacement”onpage68.
Removingorinstallingthemicroprocessor
Thissectionprovidesinstructionsonhowtoremoveorinstallthemicroprocessor.
Removingthemicroprocessor
Attention:Donotopenyourserverorattemptanyrepairbeforereadingandunderstandingthe“Safetyinformation”
onpageiii
and“Guidelines”onpage17.
Thissectionprovidesinstructionsonhowtoremovethemicroprocessor.
64ThinkServerInstallationandUserGuide