Lenovo ThinkServer 1045 - Page 85

Table15.SubmenusundertheMassStorageControllerConguration
ItemOptionDescription
SATACongurationDisabled/[Enabled]EnableordisabletheintegratedSATA
controller.
CongureSATAas[IDE]/RAID
Toselecttheharddiskdrivemode.
IfthisoptionissettoIDE,allthe
SATAconnectorswillbecongured
asstand-aloneSATAconnectors.
Notes:
1.Thesettingsin[]arethedefaultsettingsintheSetupUtilityprogram.
2.TheSATACongurationitemmightnotapplybecauseyourservercamewithanintegratedSAScontroller.
Table16.SubmenusundertheSuperIOConguration
ItemOptionDescription
SerialPort1AddressDisabled;[3F8/IRQ4];3E8/IRQ4;
2E8/IRQ3
SelecttheI/Obaseaddressand
interruptforserialport1.
SerialPort2AddressDisabled;[2F8/IRQ3];3E8/IRQ4;
2E8/IRQ3
SelecttheI/Obaseaddressand
interruptforserialport2.
Note:Thesettingsin[]arethedefaultsettingsintheSetupUtilityprogram.
Table17.SubmenusundertheUSBConguration
ItemOptionDescription
LegacyUSBSupportDisabled/[Enabled]/Auto
Enableordisablethesupporton
legacyUSBdevices.
USB2.0ControllerModeFullSpeed/[HiSpeed]SelecttheUSBspeed.
HotplugUSBFDDSupportDisabled/Enabled/[Auto]
Enableordisablethesupportonthe
hot-swapUSBdiskettedrive.
Note:Thesettingsin[]arethedefaultsettingsintheSetupUtilityprogram.
ForexternalUSBdevices,theUSBMassStorageDeviceCongurationsubmenuisasbelow:
EmulationType
[Auto]/Floppy/ForcedFDD/Hard
Disk/CDROM
SelectthetypeoftheUSBdevice.
Chapter6.Conguringtheserver75