3. Touch the static-protective package that contains the riser card to any
unpainted metal surface on the server. Then, remove the riser card from the
static-protective package.
4. Position the riser card assembly in place so that you can press the riser card
straight down into the PCI card slot on the system board. See “Locating parts
on the system board” on page 15. Then, install the two screws to secure the
riser card assembly in place. You might need a screw driver to make sure that
the screws are firmly tightened and the riser card assembly is securely installed.
Do not over-tighten the screws.
Note: You might need to press the retaining latch of the slot to secure the riser
card into the slot.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the installation, go to “Completing the parts replacement” on
page 67.
Installing or removing a PCI card
This section provides instructions on how to install or remove a PCI card.
Figure 29. Installing the riser card assembly
40 Installation and User Guide
To Next Page
Loading...
