Installing the system board battery
Attention
Do not open your server or attempt any repair before reading and understanding the Safety
Information and the Warranty and Support Information on the ThinkServer Documentation DVD
that comes with your product, and “Guidelines” on page 19. To obtain a copy of the
publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to install the system board battery.
Be sure to consider the following information when you replace the battery in the
server:
v You must replace the battery with a lithium battery of the same type from the
same manufacturer.
v After you replace the system board battery, you must reconfigure the server and
reset the system date and time.
v To avoid possible danger, read and follow the following safety statement.
Statement 2:
CAUTION:
When replacing the lithium battery, use only Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode if
not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100° C (212° F)
v Repair or disassemble
To install the system board battery, do the following:
Note: Follow any special handling and installation instructions that come with the
replacement battery.
1. Hold the system board battery 1 and position one side of the battery into its
socket. Then, press the other side of the battery until it snaps into place.
2. Make sure that the battery clip holds the battery securely.
Figure 33. Installing the system board battery
44 Installation and User Guide
To Next Page
Loading...
