Greater than 185-watt, less or equal
to 205-watt
• Processor 1: Performance heat
sink
• Processor 2: N/A
• Processor 1: Standard heat sink
• Processor 2: Performance heat
sink
Greater than 205-watt
• Processor 1: Performance heat
sink
• Processor 2: N/A
• Processor 1: N/A
• Processor 2: N/A
The following illustration shows the components of the PHM.
Figure 93. PHM components
1 Heat sink
9 Clips to secure processor in carrier
2 Heat sink triangular mark 10 Processor ejector handle
3 Processor identification label
11 Carrier triangular mark
4 Nut and wire bail retainer 12 Processor heat spreader
5 Torx T30 nut 13 Thermal grease
6 Anti-tilt wire bail 14 Processor contacts
7 Processor carrier 15 Processor triangular mark
8 Clips to secure carrier to heat sink
Procedure
Step 1. Make preparations for this task.
a. Record the processor identification label.
Chapter 5. Hardware replacement procedures 139
To Next Page
Loading...
