Lenovo ThinkSystem SD530 V3 - Pcie Riser Cable Routing

• When routing the cables, make sure that all cables are routed appropriately through the corresponding
cable guides and cable clips.
• Manage redundant fan cables as shown in the illustration.
Figure 131. Fan cable routing
From (fan) To (system board) Cable length
1 Fan 1 cable
Fan 1 connector 140 mm
2 Fan 2 cable
Fan 2 connector 140 mm
3 Fan 3 cable
Fan 3 connector 140 mm
4 Fan 4 cable
Fan 4 connector 140 mm
PCIe riser cable routing
Follow instructions in this section to route the cables for the PCIe riser.
Notes:
• Depending on the specific configuration, the information in this topic might not apply to your node.
• Connections between connectors;
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
• When routing the cables, make sure that all cables are routed appropriately through the corresponding
cable guides and cable clips.
The PCIe riser cable routing contains the following configurations:
•
“With one processor” on page 178
• “With two processors” on page 178
Chapter 6. Internal cable routing 177