Figure 64. Installation of a memory module
After this task is completed
1. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover
(see “Install the top cover” on page 170).
2. Reinstall the node into the chassis (see
“Install a node to the chassis” on page 75).
3. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
“Install a hot-swap power supply” on page 61 and “Power on the node” on page
51
.)
4. Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 171).
MicroSD card replacement
Follow instructions in this section to remove or install a MicroSD card from or to the system board.
Remove the MicroSD card
Follow instructions in this section to remove the MicroSD card.
About this task
To avoid potential danger, make sure to read and follow the safety information.
110
ThinkSystem SD530 V3 User Guide
To Next Page
Loading...
