b. Close the socket lid.
c.
Slide the socket lid to the lock position.
Figure 68. Installation of a MicroSD card
After this task is completed
1. Reconnect all the required cables to the drive backplane; then, reinstall the drive cage assembly to the
node (see
“E3.S drive backplane cable routing” on page 176 and “Install a drive cage assembly” on
page 88
).
2. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover
(see
“Install the top cover” on page 170).
3. Reinstall the node into the chassis (see
“Install a node to the chassis” on page 75).
4. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
“Install a hot-swap power supply” on page 61 and “Power on the node” on page
51
.)
5. Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 171).
OCP module replacement
Follow instructions in this section to remove or install the OCP module.
Notes:
• Depending on the specific configuration, the node might not come with this component.
• When no OCP module is installed, make sure to install an OCP filler in the OCP slot.
Remove the OCP module
Follow instructions in this section to remove to remove the OCP module.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention: Read
“Installation Guidelines” on page 41 and “Safety inspection checklist” on page 42 to make
sure that you work safely.
Procedure
Step 1. Make preparations for this task.
a. Power off the node (see
“Power off the node” on page 51).
Step 2. Remove the OCP module.
a.
Loosen the thumbscrew that secures the OCP module.
Chapter 5. Hardware replacement procedures 113
To Next Page
Loading...
