Description Type Description Type
3 Rear I/O module
T1
19 Firmware and RoT security module F
4 PCIe filler T1 20 E3.S drive filler T1
5 PCIe riser filler T1 21 E3.S drive T1
6 PCIe riser
T2
22 E3.S drive backplane
T1
7 PCIe adapter
T1
23 E3.S drive cage
T2
8 GPU air duct
T1
24 Node tray F
9 Power distribution board T2
25 Screws
T1
10 Fan T1
26 Cables
T1
11 System board
F
27 1U performance heat sink and processor
carrier
F
12 External diagnostics handset T1 28 1U standard heat sink and processor carrier F
13 M.2 drive T1 29 Heat sink support bracket F
14 M.2 drive retainer T1 30 Power bus bar T1
15 Memory module T1
31 Cable ducts
T1
16 CMOS battery (CR2032) C
Power cords
Several power cords are available, depending on the country and region where the server is installed.
To view the power cords that are available for the server:
1. Go to:
http://dcsc.lenovo.com/#/
2. Click Preconfigured Model or Configure to order.
3. Enter the machine type and model for your server to display the configurator page.
4. Click Power ➙ Power Cables to see all line cords.
Notes:
• For your safety, a power cord with a grounded attachment plug is provided to use with this product. To
avoid electrical shock, always use the power cord and plug with a properly grounded outlet.
• Power cords for this product that are used in the United States and Canada are listed by Underwriter's
Laboratories (UL) and certified by the Canadian Standards Association (CSA).
• For units intended to be operated at 115 volts: Use a UL-listed and CSA-certified cord set consisting of a
minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in length and a parallel
blade, grounding-type attachment plug rated 15 amperes, 125 volts.
• For units intended to be operated at 230 volts (U.S. use): Use a UL-listed and CSA-certified cord set
consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in length
and a tandem blade, grounding-type attachment plug rated 15 amperes, 250 volts.
• For units intended to be operated at 230 volts (outside the U.S.): Use a cord set with a grounding-type
attachment plug. The cord set should have the appropriate safety approvals for the country in which the
equipment will be installed.
• Power cords for a specific country or region are usually available only in that country or region.
Chapter 3. Parts list 33
To Next Page
Loading...
