Power distribution board cable routing
Follow instructions in this section to route the cables for the power distribution board.
Notes:
• Connections between connectors; 1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
• When routing the cables, make sure that all cables are routed appropriately through the corresponding
cable guides and cable clips.
Figure 134. Cable routing for the power distribution board
From (power distribution board) To (system board)
Cable
1 PDB sideband connector 1 Node sideband connector
Sideband 2x15 to sideband 2x15
(180 mm)
2 PDB P12V AUX power connector 2 P12V AUX power connector Power 2x6 to power 2x6 (200 mm)
Rear I/O and OCP module cable routing
Follow instructions in this section to install and route the cables for the rear I/O module and OCP module.
Notes:
• Connections between connectors; 1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
• When routing the cables, make sure that all cables are routed appropriately through the corresponding
cable guides and cable clips.
Chapter 6. Internal cable routing 179
To Next Page
Loading...
